How to attach a 4-hole binding on a 3-hole Burton board?

[harrypr]

Hi,

has anyone a clue how to fix a 4-hole binding on a 3-hole burton board?
the binding is a RAICHLE intec step-in binding...
some people say that a special disk could help but nobody can sell it as raichle stopped manufacturing...

has anyone got a hint for me?
thx

[pokkis]

Perhaps this can help you little bit, but kids dont try this at home:

http://www.flegmatic-carving.com/galler ... 0by%20domo

[sorro]

Hi Harry,

I was able to fix 3-hole burton binding on 4-hole board using 4-hole disk from a spare binding, without any customization: the Fin's disk fit perfectly the burton binding.

So now, I have 3-hole disks available that I can give you if you want. But I don't know where you are (I'm in France) and if it's worth sending. Maybe you can find 3-hole disk in shops which may have spare pieces.

If you need Raichle spare pieces, contact Deeluxe (Raichle is now Deeluxe: they changed the name)

Good luck,
Anthony.

[harrypr]

hi,

thanks for your help!

i found a nice handsome solution:

a) take the (raichle) 4 disk and widen the 2 bottom holes with a sharp knifeor a rasp
b) fix it with the screws...

and you're done.

i had no difficulties during 4 days riding in gaschurn/montafon/austria.

harry