Hi all,
When I place the bottom piece against the slot on the boot, as per the picture, in this area, the boot surface not flat, but a curve. Do I need to sand it flat? It is not mentioned in the PDF, but the video shows this area sanded down a bit (i think, picture is not that sharp).
(sorry, the picture comes out upside down)
cheers,
Slayer
ACSS for UPZ RC10 installation question
Moderators: fivat, rilliet, Arnaud, nils
ACSS for UPZ RC10 installation question
Soft: Dual 175, Burton Driver-X, Flux CV
Hard: Gen4 175M, UPZ RC10, F2 Race Titanium
Hard: Gen4 175M, UPZ RC10, F2 Race Titanium
- Capykiller
- Rank 5
- Posts: 148
- Joined: Sunday 21 October 2012, 2:04
- Location: Essen
Re: ACSS for UPZ RC10 installation question
Hi Slayer,
as you mentioned in your post I sandpaper the part a bit to make the bottom piece fit.
All the best from germany
https://youtu.be/4exQTkBn-kE
as you mentioned in your post I sandpaper the part a bit to make the bottom piece fit.
All the best from germany
https://youtu.be/4exQTkBn-kE
SWOARD Extremecarver Pro 2 168H, SWOARD Bindung Redline, SWOARD UPZ EC 12
Re: ACSS for UPZ RC10 installation question
Thanks Capykiller.
Is it critical how much to take off, or do I just make the ridge fit right-angles to the boot? Would you be able to show a closeup?
Sorry to be 'precious' - I haven't yet drilled holes in expensive boots!
I better go to my storage to find my Dremel! One thing about living in Swiss rented accomodation compared to the UK - toolbox is a lot smaller!
EDIT - now I watched the video again, and turned on the (indecipherable) auto-translate captions, I can see you mention shaving off some plastic. Need to learn more German!
cheers,
Slayer.
Is it critical how much to take off, or do I just make the ridge fit right-angles to the boot? Would you be able to show a closeup?
Sorry to be 'precious' - I haven't yet drilled holes in expensive boots!
I better go to my storage to find my Dremel! One thing about living in Swiss rented accomodation compared to the UK - toolbox is a lot smaller!
EDIT - now I watched the video again, and turned on the (indecipherable) auto-translate captions, I can see you mention shaving off some plastic. Need to learn more German!
cheers,
Slayer.
Soft: Dual 175, Burton Driver-X, Flux CV
Hard: Gen4 175M, UPZ RC10, F2 Race Titanium
Hard: Gen4 175M, UPZ RC10, F2 Race Titanium
Re: ACSS for UPZ RC10 installation question
Hi Colin
You cut a little bit the shape to get it flat
You cut a little bit the shape to get it flat
Swoard EC Pro2 168H - Swoard EC12 Boots - Gen5 168H - Stoke 162 M