to Vladimir: Take in your hands a line and check up waist. Will know much new !!!
P.S. Artem (his maker) also knew about it FROM ME !!! They making boards and even don't know them waist. It's possible only in RUSSIA !!! :-)))
PALE going wide too
Moderators: fivat, rilliet, Arnaud, nils
))
Wau 
-
webcow
- Rank 1
- Posts: 5
- Joined: Thursday 16 September 2004, 13:21
- Location: Kärnten/ Austria
- Contact:
Pale infos
Hi all
First for the Record: Pale resides in Carinthia (Austria).
Concerning the "silent" Manufacturer of Boards I can tell you what I saw when looking at their waste dump.. F2, Burton, Hot... They also have a Outlet Store at the Site where they sell these Pale Boards from stock with rather low prices. I was once told, that they sometimes sell the produced HOT Boards too (without Design of course) but after asking they told me just to come in the store and they can see what they can do
So nothing official.
Maybe somone can compare the new Dimensions of the Hot Blast with the Pale Board
Greetings from the cow.
First for the Record: Pale resides in Carinthia (Austria).
Concerning the "silent" Manufacturer of Boards I can tell you what I saw when looking at their waste dump.. F2, Burton, Hot... They also have a Outlet Store at the Site where they sell these Pale Boards from stock with rather low prices. I was once told, that they sometimes sell the produced HOT Boards too (without Design of course) but after asking they told me just to come in the store and they can see what they can do
So nothing official.Maybe somone can compare the new Dimensions of the Hot Blast with the Pale Board
Greetings from the cow.
-
nils
- Swoard founder
- Posts: 3043
- Joined: Friday 22 March 2002, 19:22
- Location: Lyon, France - Swoard team
- Contact:
well
am not sure its what happens because from what I know, hot blasts were made at grand-chavin factory until 2003-2004 when the factory closed. The production ( belonging to hammer which belongs to rossignol) was then taken back the rossignol main factory in spain. Where it is supposed to be still... but maybe it has changed > would be interesting to ask the question to Dédé hammer/hot shaper about this.
Nils
Nils