ACSS - Advanced Carving Spring System for Deeluxe

[scope2000]

Hello Abrax

I'm impressed about your job with your ACSS. It's time for my comeback on the edge. (We're still alive)

You have got a PM with my order but the PM is still in my outbox...very strange
Please let me know if you have my order.

Thanks in advance.
Christoph

[Abrax]

Hi Scope, Yes I have received your order today at 1:20 AM so everything is fine.

Forum keeps it in your outbox and this allows you to edit the message till it is read. Once I read it you can't edit it anymore

[fmasoni3]

Hi Abrax, you have a PM from me

[M1H4]

Abrax, i sent you an email to abrax@swoard.com with order.

Best regards, M

[Parallax]

ACSS works perfect with my Deeluxe 225

[FaF]

Abrax, i send you a PM 2 days ago.
No post from you since 2013. Are you alive ???

[Abrax]

Yeap, big changes in my life But I am here and I'm gonna reply to everyone right after I will get some sleep Finally... Dudes, thanks for waiting and understanding...

[Micky]

Yeap, big changes in my life But I am here and I'm gonna reply to everyone right after I will get some sleep Finally... Dudes, thanks for waiting and understanding...

[varis]

On Deeluxe Track 325, how are you supposed to remove the 2 bolts (step #1)? Tried grabbing with some pliers and rotating but there is not much to grab... especially on the lower one.

[christian61]

On Deeluxe Track 325, how are you supposed to remove the 2 bolts (step #1)? Tried grabbing with some pliers and rotating but there is not much to grab... especially on the lower one.

No pliers! Use a screw like this (a little bit thinnner than the bolt)
http://www.paulwiegand.de/idoc/images/S ... 171045.jpg
and a hammer to drive the bolt out. It takes some force, but be careful to drive it out in the right direction, as shown in picture 1 at the beginning of this thread.

[Abrax]

You should take 5mm or a bit thinner bolt and try to punch the bolts out with the additional one with a hammer.

Once it goes out 3-4 mm check if there is a rough surface comming out. If not, please punch the bolt in the oposite direction.

ACSS guys -> I thought it will be easier. It's not. I will do my best to reply all the e-mails (thank you! ) at last on Sunday!

[Parallax]

Abrax is a dad now )
Congrats!x!

[Fefe]

Congrats!

[nextcarve]

After I received my ACSS, I put it on my Deeluxe 325. Next day I went on the slope to try it out. The conditions were a mixture of soft and hard snow.
And it came like it had to come. In a soft part my snowboard just dug into the snow and was stopped abruptly by a hard spot. I was just catapulted to the front.

Unfortunately the ACSS has no limit for overbending. My ankle joint was compressed hard and my calf was overstretched to the limit.

I hurt myself very badly!

I don't want to give ACSS and its builder a bad reputation, but it has a serious safety problem and you risk to get injured.
Perhaps after my feedback abrax thinks of changing the design in a way ACSS limits dangerous overstretching.

After this accident the season 2013/14 has ended for me, because I will not recover fast enough

[Parallax]

Hi!
It's very pity..

Extremecarving is dangerous sport..it's extreme.
And your mistakes can be fatal. I think nose-dive can occure this injure with any boot's system.