Edge Sharpening - Extremecarver and Dual
Moderators: fivat, rilliet, nils
Re: Edge Sharpening - Extremecarver and Dual
I propose to use diamonfile instead file when checking angle, just to save some extra wear
Re: Edge Sharpening - Extremecarver and Dual
I agreeArnaud wrote:yes, strange
about 0.5° / 1° come from the factory (sanding on a rubber cylinder), and 90° side angle because it avoid tool setting But works perfectly in powder
Pietro
... sciare in pista è come nuotare in piscina, sciare in fuoripista è come farlo in mare aperto ...
... sciare in pista è come nuotare in piscina, sciare in fuoripista è come farlo in mare aperto ...